:	Feb 16, 2007

.

Disconnect the battery ground cable.

.

Remove the battery tray.

.

Remove the engine control module (ECM).

.

Remove the battery junction box (BJB) cover.   Release the clip.

.

Release the BJB from the bracket.   Remove the bolt.

.

Remove the central junction box (CJB).

.

Release the CJB bracket.   Release the 3 upper wiring harness clips.   Remove the 2 bolts.

.

Remove the CJB bracket.   Disconnect the 2 electrical connectors.   Release the 3 lower wiring harness clips.   Remove the 2 nuts.

.

Release the ECM housing.   Release the insulation for access to the nuts.   Remove the 2 nuts and 2 bolts.

.

: Note of the routing of the wiring harnesses. Release and disconnect the ECM cooling fan electrical connector.

.

Remove the ECM housing lower panel.   Remove the 4 screws.

.

: Note the fitted position of the component prior to removal. Remove the cooling fan.   Remove the 2 screws.

.

: Make sure that these components are installed to the noted removal position. Install the cooling fan.   Install the 2 screws.

.

: Make sure the seal is installed correctly. Install the ECM housing lower panel.   Install the 4 screws.

.

: Make sure that the wiring harnesses are correctly routed. Connect and secure the cooling fan electrical connector.

.

: Make sure that the seal is correctly located. Secure the ECM housing.   Tighten the bolts and nuts to 10 Nm (7 lb.ft).

.

Install the CJB bracket.   Tighten the nuts to 10 Nm (7 lb.ft).   Secure the clips.   Connect the electrical connectors.   Tighten the bolts to 25 Nm (18 lb.ft).

.

Install the CJB.

.

Secure the BJB to the bracket.   Tighten the bolt to 6 Nm (4 lb.ft).

.

Install the BJB cover.   Secure the clip.

.

Install the engine ECM.

.

Install the battery tray.

.

Connect the battery ground cable.